Opensource cw decoder software#
Open source firmware, built into ide allows experimentation, can add new features, can share contributions through github, software complexity: 2000 lines of code-V-based software can be used for fast complete rogue operations (qsk and semi-qsk), or auxiliary execution in digital mode (without cat or ptt interface) for rx/tx switch, with tx/pa delay control External ptt output-Simple installation and modification, 8 component changes and 8 wires
Opensource cw decoder driver#
Eer e-level drive ssb launch stage-13.8v power source about 10w ssb pep output-Full mode support: usb, lsb, cw, am, fm-dsp filter: 4000, 2500, 1700, 500, 200, 100, 50hz passband-dsp function: control automatic gain (agc), noise reduction (nr), voice trigger, voice trigger xmit, attenuator rx (att), tx noise gate, tx driver control, volume control, dbm/s-meter-Ssb reverse sideband/carrier suppression transmission: better than -45dbc, imd3 (dual tone) -33dbc, reception: better than -50dbc -Multi-band support, continuously adjustable in the 160m-10m frequency range (with loss of 20khz performance ). There is no need for complicated transformer windings, and no wiring procedures, the most cost-effective and easy to construct. The original qcx circuit is greatly simplified, and the installed components are reduced by 50%. Aluminum laser shell marking, all aluminum buttons, translucent silicone keys.4. Can be used to connect the antenna (meter base).3. This QRP SSB/CW shortwave transceiver has a 1602 screen, built-in battery, equipped with a charger, built-in microphone, speaker, can be connected to an automatic key, and can also be CW decoded.ġ.
0 kommentar(er)
